linux-next/drivers/clk/qcom/clk-hfpll.c
Adam Skladowski 500a4609ee clk: qcom: clk-hfpll: Configure l_val in init when required
Add support for pre-configuring default frequency multiplier,
this appears to be required on some platforms like MSM8976.
Without configuring L_VAL device reboots when trying to bring PLL up.

Signed-off-by: Adam Skladowski <a39.skl@gmail.com>
Reviewed-by: Konrad Dybcio <konrad.dybcio@linaro.org>
Link: https://lore.kernel.org/r/20230812112534.8610-3-a39.skl@gmail.com
Signed-off-by: Bjorn Andersson <andersson@kernel.org>
2023-09-13 12:07:58 -07:00

254 lines
6.1 KiB
C

// SPDX-License-Identifier: GPL-2.0
// Copyright (c) 2018, The Linux Foundation. All rights reserved.
#include <linux/kernel.h>
#include <linux/export.h>
#include <linux/regmap.h>
#include <linux/delay.h>
#include <linux/err.h>
#include <linux/clk-provider.h>
#include <linux/spinlock.h>
#include "clk-regmap.h"
#include "clk-hfpll.h"
#define PLL_OUTCTRL BIT(0)
#define PLL_BYPASSNL BIT(1)
#define PLL_RESET_N BIT(2)
/* Initialize a HFPLL at a given rate and enable it. */
static void __clk_hfpll_init_once(struct clk_hw *hw)
{
struct clk_hfpll *h = to_clk_hfpll(hw);
struct hfpll_data const *hd = h->d;
struct regmap *regmap = h->clkr.regmap;
if (likely(h->init_done))
return;
/* Configure PLL parameters for integer mode. */
if (hd->config_val)
regmap_write(regmap, hd->config_reg, hd->config_val);
regmap_write(regmap, hd->m_reg, 0);
regmap_write(regmap, hd->n_reg, 1);
if (hd->user_reg) {
u32 regval = hd->user_val;
unsigned long rate;
rate = clk_hw_get_rate(hw);
/* Pick the right VCO. */
if (hd->user_vco_mask && rate > hd->low_vco_max_rate)
regval |= hd->user_vco_mask;
regmap_write(regmap, hd->user_reg, regval);
}
/* Write L_VAL from conf if it exist */
if (hd->l_val)
regmap_write(regmap, hd->l_reg, hd->l_val);
if (hd->droop_reg)
regmap_write(regmap, hd->droop_reg, hd->droop_val);
h->init_done = true;
}
static void __clk_hfpll_enable(struct clk_hw *hw)
{
struct clk_hfpll *h = to_clk_hfpll(hw);
struct hfpll_data const *hd = h->d;
struct regmap *regmap = h->clkr.regmap;
u32 val;
__clk_hfpll_init_once(hw);
/* Disable PLL bypass mode. */
regmap_update_bits(regmap, hd->mode_reg, PLL_BYPASSNL, PLL_BYPASSNL);
/*
* H/W requires a 5us delay between disabling the bypass and
* de-asserting the reset. Delay 10us just to be safe.
*/
udelay(10);
/* De-assert active-low PLL reset. */
regmap_update_bits(regmap, hd->mode_reg, PLL_RESET_N, PLL_RESET_N);
/* Wait for PLL to lock. */
if (hd->status_reg)
/*
* Busy wait. Should never timeout, we add a timeout to
* prevent any sort of stall.
*/
regmap_read_poll_timeout(regmap, hd->status_reg, val,
!(val & BIT(hd->lock_bit)), 0,
100 * USEC_PER_MSEC);
else
udelay(60);
/* Enable PLL output. */
regmap_update_bits(regmap, hd->mode_reg, PLL_OUTCTRL, PLL_OUTCTRL);
}
/* Enable an already-configured HFPLL. */
static int clk_hfpll_enable(struct clk_hw *hw)
{
unsigned long flags;
struct clk_hfpll *h = to_clk_hfpll(hw);
struct hfpll_data const *hd = h->d;
struct regmap *regmap = h->clkr.regmap;
u32 mode;
spin_lock_irqsave(&h->lock, flags);
regmap_read(regmap, hd->mode_reg, &mode);
if (!(mode & (PLL_BYPASSNL | PLL_RESET_N | PLL_OUTCTRL)))
__clk_hfpll_enable(hw);
spin_unlock_irqrestore(&h->lock, flags);
return 0;
}
static void __clk_hfpll_disable(struct clk_hfpll *h)
{
struct hfpll_data const *hd = h->d;
struct regmap *regmap = h->clkr.regmap;
/*
* Disable the PLL output, disable test mode, enable the bypass mode,
* and assert the reset.
*/
regmap_update_bits(regmap, hd->mode_reg,
PLL_BYPASSNL | PLL_RESET_N | PLL_OUTCTRL, 0);
}
static void clk_hfpll_disable(struct clk_hw *hw)
{
struct clk_hfpll *h = to_clk_hfpll(hw);
unsigned long flags;
spin_lock_irqsave(&h->lock, flags);
__clk_hfpll_disable(h);
spin_unlock_irqrestore(&h->lock, flags);
}
static int clk_hfpll_determine_rate(struct clk_hw *hw, struct clk_rate_request *req)
{
struct clk_hfpll *h = to_clk_hfpll(hw);
struct hfpll_data const *hd = h->d;
unsigned long rrate;
req->rate = clamp(req->rate, hd->min_rate, hd->max_rate);
rrate = DIV_ROUND_UP(req->rate, req->best_parent_rate) * req->best_parent_rate;
if (rrate > hd->max_rate)
rrate -= req->best_parent_rate;
req->rate = rrate;
return 0;
}
/*
* For optimization reasons, assumes no downstream clocks are actively using
* it.
*/
static int clk_hfpll_set_rate(struct clk_hw *hw, unsigned long rate,
unsigned long parent_rate)
{
struct clk_hfpll *h = to_clk_hfpll(hw);
struct hfpll_data const *hd = h->d;
struct regmap *regmap = h->clkr.regmap;
unsigned long flags;
u32 l_val, val;
bool enabled;
l_val = rate / parent_rate;
spin_lock_irqsave(&h->lock, flags);
enabled = __clk_is_enabled(hw->clk);
if (enabled)
__clk_hfpll_disable(h);
/* Pick the right VCO. */
if (hd->user_reg && hd->user_vco_mask) {
regmap_read(regmap, hd->user_reg, &val);
if (rate <= hd->low_vco_max_rate)
val &= ~hd->user_vco_mask;
else
val |= hd->user_vco_mask;
regmap_write(regmap, hd->user_reg, val);
}
regmap_write(regmap, hd->l_reg, l_val);
if (enabled)
__clk_hfpll_enable(hw);
spin_unlock_irqrestore(&h->lock, flags);
return 0;
}
static unsigned long clk_hfpll_recalc_rate(struct clk_hw *hw,
unsigned long parent_rate)
{
struct clk_hfpll *h = to_clk_hfpll(hw);
struct hfpll_data const *hd = h->d;
struct regmap *regmap = h->clkr.regmap;
u32 l_val;
regmap_read(regmap, hd->l_reg, &l_val);
return l_val * parent_rate;
}
static int clk_hfpll_init(struct clk_hw *hw)
{
struct clk_hfpll *h = to_clk_hfpll(hw);
struct hfpll_data const *hd = h->d;
struct regmap *regmap = h->clkr.regmap;
u32 mode, status;
regmap_read(regmap, hd->mode_reg, &mode);
if (mode != (PLL_BYPASSNL | PLL_RESET_N | PLL_OUTCTRL)) {
__clk_hfpll_init_once(hw);
return 0;
}
if (hd->status_reg) {
regmap_read(regmap, hd->status_reg, &status);
if (!(status & BIT(hd->lock_bit))) {
WARN(1, "HFPLL %s is ON, but not locked!\n",
__clk_get_name(hw->clk));
clk_hfpll_disable(hw);
__clk_hfpll_init_once(hw);
}
}
return 0;
}
static int hfpll_is_enabled(struct clk_hw *hw)
{
struct clk_hfpll *h = to_clk_hfpll(hw);
struct hfpll_data const *hd = h->d;
struct regmap *regmap = h->clkr.regmap;
u32 mode;
regmap_read(regmap, hd->mode_reg, &mode);
mode &= 0x7;
return mode == (PLL_BYPASSNL | PLL_RESET_N | PLL_OUTCTRL);
}
const struct clk_ops clk_ops_hfpll = {
.enable = clk_hfpll_enable,
.disable = clk_hfpll_disable,
.is_enabled = hfpll_is_enabled,
.determine_rate = clk_hfpll_determine_rate,
.set_rate = clk_hfpll_set_rate,
.recalc_rate = clk_hfpll_recalc_rate,
.init = clk_hfpll_init,
};
EXPORT_SYMBOL_GPL(clk_ops_hfpll);