mirror of
https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git
synced 2024-12-28 16:56:26 +00:00
39671a14df
Driver for Renesas ISL28022 power monitor with I2C interface. The device monitors voltage, current via shunt resistor and calculated power. Signed-off-by: Carsten Spieß <mail@carsten-spiess.de> Signed-off-by: Yikai Tsai <yikai.tsai.wiwynn@gmail.com> Message-ID: <20241002081133.13123-3-yikai.tsai.wiwynn@gmail.com> [groeck: Fixed alignment issues, dropped noise at end of probe] Signed-off-by: Guenter Roeck <linux@roeck-us.net>
64 lines
1.8 KiB
ReStructuredText
64 lines
1.8 KiB
ReStructuredText
.. SPDX-License-Identifier: GPL-2.0-or-later
|
|
|
|
Kernel driver isl28022
|
|
======================
|
|
|
|
Supported chips:
|
|
|
|
* Renesas ISL28022
|
|
|
|
Prefix: 'isl28022'
|
|
|
|
Addresses scanned: none
|
|
|
|
Datasheet: Publicly available at the Renesas website
|
|
|
|
https://www.renesas.com/us/en/www/doc/datasheet/isl28022.pdf
|
|
|
|
Author:
|
|
Carsten Spieß <mail@carsten-spiess.de>
|
|
|
|
Description
|
|
-----------
|
|
|
|
The ISL28022 is a power monitor with I2C interface. The device monitors
|
|
voltage, current via shunt resistor and calculated power.
|
|
|
|
Usage Notes
|
|
-----------
|
|
|
|
This driver does not auto-detect devices. You will have to instantiate the
|
|
device explicitly. Please see Documentation/i2c/instantiating-devices.rst for
|
|
details.
|
|
|
|
The shunt value in micro-ohms, shunt voltage range and averaging can be set
|
|
with device properties.
|
|
Please refer to the Documentation/devicetree/bindings/hwmon/isl,isl28022.yaml
|
|
for bindings if the device tree is used.
|
|
|
|
The driver supports only shunt and bus continuous ADC mode at 15bit resolution.
|
|
Averaging can be set from 1 to 128 samples (power of 2) on both channels.
|
|
Shunt voltage range of 40, 80, 160 or 320mV is allowed
|
|
The bus voltage range is 60V fixed.
|
|
|
|
Sysfs entries
|
|
-------------
|
|
|
|
The following attributes are supported. All attributes are read-only.
|
|
|
|
======================= =======================================================
|
|
in0_input bus voltage (milli Volt)
|
|
|
|
curr1_input current (milli Ampere)
|
|
power1_input power (micro Watt)
|
|
======================= =======================================================
|
|
|
|
Debugfs entries
|
|
---------------
|
|
|
|
The following attributes are supported. All attributes are read-only.
|
|
|
|
======================= =======================================================
|
|
shunt_voltage shunt voltage (micro Volt)
|
|
======================= =======================================================
|