linux-stable/drivers/pwm/pwm-adp5585.c

// SPDX-License-Identifier: GPL-2.0-only
/*
 * Analog Devices ADP5585 PWM driver
 *
 * Copyright 2022 NXP
 * Copyright 2024 Ideas on Board Oy
 *
 * Limitations:
 * - The .apply() operation executes atomically, but may not wait for the
 *   period to complete (this is not documented and would need to be tested).
 * - Disabling the PWM drives the output pin to a low level immediately.
 * - The hardware can only generate normal polarity output.
 */

#include <asm/byteorder.h>

#include <linux/device.h>
#include <linux/err.h>
#include <linux/math64.h>
#include <linux/mfd/adp5585.h>
#include <linux/minmax.h>
#include <linux/module.h>
#include <linux/platform_device.h>
#include <linux/pwm.h>
#include <linux/regmap.h>
#include <linux/time.h>
#include <linux/types.h>

#define ADP5585_PWM_CHAN_NUM		1

#define ADP5585_PWM_OSC_FREQ_HZ		1000000U
#define ADP5585_PWM_MIN_PERIOD_NS	(2ULL * NSEC_PER_SEC / ADP5585_PWM_OSC_FREQ_HZ)
#define ADP5585_PWM_MAX_PERIOD_NS	(2ULL * 0xffff * NSEC_PER_SEC / ADP5585_PWM_OSC_FREQ_HZ)

static int pwm_adp5585_request(struct pwm_chip *chip, struct pwm_device *pwm)
{
	struct regmap *regmap = pwmchip_get_drvdata(chip);

	/* Configure the R3 pin as PWM output. */
	return regmap_update_bits(regmap, ADP5585_PIN_CONFIG_C,
				  ADP5585_R3_EXTEND_CFG_MASK,
				  ADP5585_R3_EXTEND_CFG_PWM_OUT);
}

static void pwm_adp5585_free(struct pwm_chip *chip, struct pwm_device *pwm)
{
	struct regmap *regmap = pwmchip_get_drvdata(chip);

	regmap_update_bits(regmap, ADP5585_PIN_CONFIG_C,
			   ADP5585_R3_EXTEND_CFG_MASK,
			   ADP5585_R3_EXTEND_CFG_GPIO4);
}

static int pwm_adp5585_apply(struct pwm_chip *chip,
			     struct pwm_device *pwm,
			     const struct pwm_state *state)
{
	struct regmap *regmap = pwmchip_get_drvdata(chip);
	u64 period, duty_cycle;
	u32 on, off;
	__le16 val;
	int ret;

	if (!state->enabled) {
		regmap_clear_bits(regmap, ADP5585_GENERAL_CFG, ADP5585_OSC_EN);
		regmap_clear_bits(regmap, ADP5585_PWM_CFG, ADP5585_PWM_EN);
		return 0;
	}

	if (state->polarity != PWM_POLARITY_NORMAL)
		return -EINVAL;

	if (state->period < ADP5585_PWM_MIN_PERIOD_NS)
		return -EINVAL;

	period = min(state->period, ADP5585_PWM_MAX_PERIOD_NS);
	duty_cycle = min(state->duty_cycle, period);

	/*
	 * Compute the on and off time. As the internal oscillator frequency is
	 * 1MHz, the calculation can be simplified without loss of precision.
	 */
	on = div_u64(duty_cycle, NSEC_PER_SEC / ADP5585_PWM_OSC_FREQ_HZ);
	off = div_u64(period, NSEC_PER_SEC / ADP5585_PWM_OSC_FREQ_HZ) - on;

	val = cpu_to_le16(off);
	ret = regmap_bulk_write(regmap, ADP5585_PWM_OFFT_LOW, &val, 2);
	if (ret)
		return ret;

	val = cpu_to_le16(on);
	ret = regmap_bulk_write(regmap, ADP5585_PWM_ONT_LOW, &val, 2);
	if (ret)
		return ret;

	/* Enable PWM in continuous mode and no external AND'ing. */
	ret = regmap_update_bits(regmap, ADP5585_PWM_CFG,
				 ADP5585_PWM_IN_AND | ADP5585_PWM_MODE |
				 ADP5585_PWM_EN, ADP5585_PWM_EN);
	if (ret)
		return ret;

	ret = regmap_set_bits(regmap, ADP5585_GENERAL_CFG, ADP5585_OSC_EN);
	if (ret)
		return ret;

	return regmap_set_bits(regmap, ADP5585_PWM_CFG, ADP5585_PWM_EN);
}

static int pwm_adp5585_get_state(struct pwm_chip *chip,
				 struct pwm_device *pwm,
				 struct pwm_state *state)
{
	struct regmap *regmap = pwmchip_get_drvdata(chip);
	unsigned int on, off;
	unsigned int val;
	__le16 on_off;
	int ret;

	ret = regmap_bulk_read(regmap, ADP5585_PWM_OFFT_LOW, &on_off, 2);
	if (ret)
		return ret;
	off = le16_to_cpu(on_off);

	ret = regmap_bulk_read(regmap, ADP5585_PWM_ONT_LOW, &on_off, 2);
	if (ret)
		return ret;
	on = le16_to_cpu(on_off);

	state->duty_cycle = on * (NSEC_PER_SEC / ADP5585_PWM_OSC_FREQ_HZ);
	state->period = (on + off) * (NSEC_PER_SEC / ADP5585_PWM_OSC_FREQ_HZ);

	state->polarity = PWM_POLARITY_NORMAL;

	regmap_read(regmap, ADP5585_PWM_CFG, &val);
	state->enabled = !!(val & ADP5585_PWM_EN);

	return 0;
}

static const struct pwm_ops adp5585_pwm_ops = {
	.request = pwm_adp5585_request,
	.free = pwm_adp5585_free,
	.apply = pwm_adp5585_apply,
	.get_state = pwm_adp5585_get_state,
};

static int adp5585_pwm_probe(struct platform_device *pdev)
{
	struct device *dev = &pdev->dev;
	struct adp5585_dev *adp5585 = dev_get_drvdata(dev->parent);
	struct pwm_chip *chip;
	int ret;

	chip = devm_pwmchip_alloc(dev, ADP5585_PWM_CHAN_NUM, 0);
	if (IS_ERR(chip))
		return PTR_ERR(chip);

	device_set_of_node_from_dev(dev, dev->parent);

	pwmchip_set_drvdata(chip, adp5585->regmap);
	chip->ops = &adp5585_pwm_ops;

	ret = devm_pwmchip_add(dev, chip);
	if (ret)
		return dev_err_probe(dev, ret, "failed to add PWM chip\n");

	return 0;
}

static const struct platform_device_id adp5585_pwm_id_table[] = {
	{ "adp5585-pwm" },
	{ /* Sentinel */ }
};
MODULE_DEVICE_TABLE(platform, adp5585_pwm_id_table);

static struct platform_driver adp5585_pwm_driver = {
	.driver	= {
		.name = "adp5585-pwm",
	},
	.probe = adp5585_pwm_probe,
	.id_table = adp5585_pwm_id_table,
};
module_platform_driver(adp5585_pwm_driver);

MODULE_AUTHOR("Xiaoning Wang <xiaoning.wang@nxp.com>");
MODULE_DESCRIPTION("ADP5585 PWM Driver");
MODULE_LICENSE("GPL");