clocksource/drivers/timer-atmel-tcb: Fix initialization on SAM9 hardware

On SAM9 hardware two cascaded 16 bit timers are used to form a 32 bit
high resolution timer that is used as scheduler clock when the kernel
has been configured that way (CONFIG_ATMEL_CLOCKSOURCE_TCB).

The driver initially triggers a reset-to-zero of the two timers but this
reset is only performed on the next rising clock. For the first timer
this is ok - it will be in the next 60ns (16MHz clock). For the chained
second timer this will only happen after the first timer overflows, i.e.
after 2^16 clocks (~4ms with a 16MHz clock). So with other words the
scheduler clock resets to 0 after the first 2^16 clock cycles.

It looks like that the scheduler does not like this and behaves wrongly
over its lifetime, e.g. some tasks are scheduled with a long delay. Why
that is and if there are additional requirements for this behaviour has
not been further analysed.

There is a simple fix for resetting the second timer as well when the
first timer is reset and this is to set the ATMEL_TC_ASWTRG_SET bit in
the Channel Mode register (CMR) of the first timer. This will also rise
the TIOA line (clock input of the second timer) when a software trigger
respective SYNC is issued.

Signed-off-by: Ronald Wahl <ronald.wahl@raritan.com>
Acked-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
Signed-off-by: Daniel Lezcano <daniel.lezcano@linaro.org>
Link: https://lore.kernel.org/r/20231007161803.31342-1-rwahl@gmx.de

drivers/clocksource/timer-atmel-tcb.c

@@ -315,6 +315,7 @@ static void __init tcb_setup_dual_chan(struct atmel_tc *tc, int mck_divisor_idx)
 	writel(mck_divisor_idx			/* likely divide-by-8 */
 			| ATMEL_TC_WAVE
 			| ATMEL_TC_WAVESEL_UP		/* free-run */
+			| ATMEL_TC_ASWTRG_SET		/* TIOA0 rises at software trigger */
 			| ATMEL_TC_ACPA_SET		/* TIOA0 rises at 0 */
 			| ATMEL_TC_ACPC_CLEAR,		/* (duty cycle 50%) */
 			tcaddr + ATMEL_TC_REG(0, CMR));