The continual trickle of small conversion patches is grating on me, and
is really not helping. Just get rid of the 'remove_new' member
function, which is just an alias for the plain 'remove', and had a
comment to that effect:
/*
* .remove_new() is a relic from a prototype conversion of .remove().
* New drivers are supposed to implement .remove(). Once all drivers are
* converted to not use .remove_new any more, it will be dropped.
*/
This was just a tree-wide 'sed' script that replaced '.remove_new' with
'.remove', with some care taken to turn a subsequent tab into two tabs
to make things line up.
I did do some minimal manual whitespace adjustment for places that used
spaces to line things up.
Then I just removed the old (sic) .remove_new member function, and this
is the end result. No more unnecessary conversion noise.
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
There are following smatch warning:
drivers/extcon/extcon-rtk-type-c.c:905 __updated_type_c_parameter_by_efuse()
error: 'buf' dereferencing possible ERR_PTR()
The nvmem_cell_read may fail to read. So, driver must handle failure cases.
Link: https://lore.kernel.org/all/20231016053510.28881-1-stanley_chang@realtek.com/
Fixes: 8a590d7371f0 ("extcon: add Realtek DHC RTD SoC Type-C driver")
Reported-by: Dan Carpenter <dan.carpenter@linaro.org>
Closes: https://lore.kernel.org/all/a469dd51-f5d5-4e8f-ba36-6c7cea046fb8@moroto.mountain/
Signed-off-by: Stanley Chang <stanley_chang@realtek.com>
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
This patch adds the extcon driver for Realtek DHC (digital home center)
RTD SoCs type-c module. This can be used to detect whether the port is
configured as a downstream or upstream facing port. And notify the status
of extcon to listeners.
Link: https://lore.kernel.org/lkml/20230904051253.23208-2-stanley_chang@realtek.com/
Signed-off-by: Stanley Chang <stanley_chang@realtek.com>
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
