linux/drivers/thermal/dove_thermal.c
Uwe Kleine-König dd64594ca2 thermal: Switch back to struct platform_driver::remove()
After commit 0edb555a65 ("platform: Make platform_driver::remove()
return void") .remove() is (again) the right callback to implement for
platform drivers.

Convert all platform drivers below drivers/thermal to use .remove(), with
the eventual goal to drop struct platform_driver::remove_new(). As
.remove() and .remove_new() have the same prototypes, conversion is done
by just changing the structure member name in the driver initializer.

On the way make a few whitespace changes to make indention consistent.

Signed-off-by: Uwe Kleine-König <u.kleine-koenig@baylibre.com>
Link: https://lore.kernel.org/r/20241019163412.304422-2-u.kleine-koenig@baylibre.com
Signed-off-by: Daniel Lezcano <daniel.lezcano@linaro.org>
2024-11-13 16:17:57 +01:00

185 lines
4.5 KiB
C

// SPDX-License-Identifier: GPL-2.0-only
/*
* Dove thermal sensor driver
*
* Copyright (C) 2013 Andrew Lunn <andrew@lunn.ch>
*/
#include <linux/device.h>
#include <linux/err.h>
#include <linux/io.h>
#include <linux/kernel.h>
#include <linux/of.h>
#include <linux/module.h>
#include <linux/platform_device.h>
#include <linux/thermal.h>
#define DOVE_THERMAL_TEMP_OFFSET 1
#define DOVE_THERMAL_TEMP_MASK 0x1FF
/* Dove Thermal Manager Control and Status Register */
#define PMU_TM_DISABLE_OFFS 0
#define PMU_TM_DISABLE_MASK (0x1 << PMU_TM_DISABLE_OFFS)
/* Dove Theraml Diode Control 0 Register */
#define PMU_TDC0_SW_RST_MASK (0x1 << 1)
#define PMU_TDC0_SEL_VCAL_OFFS 5
#define PMU_TDC0_SEL_VCAL_MASK (0x3 << PMU_TDC0_SEL_VCAL_OFFS)
#define PMU_TDC0_REF_CAL_CNT_OFFS 11
#define PMU_TDC0_REF_CAL_CNT_MASK (0x1FF << PMU_TDC0_REF_CAL_CNT_OFFS)
#define PMU_TDC0_AVG_NUM_OFFS 25
#define PMU_TDC0_AVG_NUM_MASK (0x7 << PMU_TDC0_AVG_NUM_OFFS)
/* Dove Thermal Diode Control 1 Register */
#define PMU_TEMP_DIOD_CTRL1_REG 0x04
#define PMU_TDC1_TEMP_VALID_MASK (0x1 << 10)
/* Dove Thermal Sensor Dev Structure */
struct dove_thermal_priv {
void __iomem *sensor;
void __iomem *control;
};
static int dove_init_sensor(const struct dove_thermal_priv *priv)
{
u32 reg;
u32 i;
/* Configure the Diode Control Register #0 */
reg = readl_relaxed(priv->control);
/* Use average of 2 */
reg &= ~PMU_TDC0_AVG_NUM_MASK;
reg |= (0x1 << PMU_TDC0_AVG_NUM_OFFS);
/* Reference calibration value */
reg &= ~PMU_TDC0_REF_CAL_CNT_MASK;
reg |= (0x0F1 << PMU_TDC0_REF_CAL_CNT_OFFS);
/* Set the high level reference for calibration */
reg &= ~PMU_TDC0_SEL_VCAL_MASK;
reg |= (0x2 << PMU_TDC0_SEL_VCAL_OFFS);
writel(reg, priv->control);
/* Reset the sensor */
reg = readl_relaxed(priv->control);
writel((reg | PMU_TDC0_SW_RST_MASK), priv->control);
writel(reg, priv->control);
/* Enable the sensor */
reg = readl_relaxed(priv->sensor);
reg &= ~PMU_TM_DISABLE_MASK;
writel(reg, priv->sensor);
/* Poll the sensor for the first reading */
for (i = 0; i < 1000000; i++) {
reg = readl_relaxed(priv->sensor);
if (reg & DOVE_THERMAL_TEMP_MASK)
break;
}
if (i == 1000000)
return -EIO;
return 0;
}
static int dove_get_temp(struct thermal_zone_device *thermal,
int *temp)
{
unsigned long reg;
struct dove_thermal_priv *priv = thermal_zone_device_priv(thermal);
/* Valid check */
reg = readl_relaxed(priv->control + PMU_TEMP_DIOD_CTRL1_REG);
if ((reg & PMU_TDC1_TEMP_VALID_MASK) == 0x0)
return -EIO;
/*
* Calculate temperature. According to Marvell internal
* documentation the formula for this is:
* Celsius = (322-reg)/1.3625
*/
reg = readl_relaxed(priv->sensor);
reg = (reg >> DOVE_THERMAL_TEMP_OFFSET) & DOVE_THERMAL_TEMP_MASK;
*temp = ((3220000000UL - (10000000UL * reg)) / 13625);
return 0;
}
static struct thermal_zone_device_ops ops = {
.get_temp = dove_get_temp,
};
static const struct of_device_id dove_thermal_id_table[] = {
{ .compatible = "marvell,dove-thermal" },
{}
};
static int dove_thermal_probe(struct platform_device *pdev)
{
struct thermal_zone_device *thermal = NULL;
struct dove_thermal_priv *priv;
int ret;
priv = devm_kzalloc(&pdev->dev, sizeof(*priv), GFP_KERNEL);
if (!priv)
return -ENOMEM;
priv->sensor = devm_platform_get_and_ioremap_resource(pdev, 0, NULL);
if (IS_ERR(priv->sensor))
return PTR_ERR(priv->sensor);
priv->control = devm_platform_get_and_ioremap_resource(pdev, 1, NULL);
if (IS_ERR(priv->control))
return PTR_ERR(priv->control);
ret = dove_init_sensor(priv);
if (ret) {
dev_err(&pdev->dev, "Failed to initialize sensor\n");
return ret;
}
thermal = thermal_tripless_zone_device_register("dove_thermal", priv,
&ops, NULL);
if (IS_ERR(thermal)) {
dev_err(&pdev->dev,
"Failed to register thermal zone device\n");
return PTR_ERR(thermal);
}
ret = thermal_zone_device_enable(thermal);
if (ret) {
thermal_zone_device_unregister(thermal);
return ret;
}
platform_set_drvdata(pdev, thermal);
return 0;
}
static void dove_thermal_exit(struct platform_device *pdev)
{
struct thermal_zone_device *dove_thermal =
platform_get_drvdata(pdev);
thermal_zone_device_unregister(dove_thermal);
}
MODULE_DEVICE_TABLE(of, dove_thermal_id_table);
static struct platform_driver dove_thermal_driver = {
.probe = dove_thermal_probe,
.remove = dove_thermal_exit,
.driver = {
.name = "dove_thermal",
.of_match_table = dove_thermal_id_table,
},
};
module_platform_driver(dove_thermal_driver);
MODULE_AUTHOR("Andrew Lunn <andrew@lunn.ch>");
MODULE_DESCRIPTION("Dove thermal driver");
MODULE_LICENSE("GPL");