mirror of
https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git
synced 2024-12-29 17:25:38 +00:00
c1b0b32f2d
[ Upstream commit 3fde2fe99a ]
According to SP800-90B, two health failures are allowed: the intermittend
and the permanent failure. So far, only the intermittent failure was
implemented. The permanent failure was achieved by resetting the entire
entropy source including its health test state and waiting for two or
more back-to-back health errors.
This approach is appropriate for RCT, but not for APT as APT has a
non-linear cutoff value. Thus, this patch implements 2 cutoff values
for both RCT/APT. This implies that the health state is left untouched
when an intermittent failure occurs. The noise source is reset
and a new APT powerup-self test is performed. Yet, whith the unchanged
health test state, the counting of failures continues until a permanent
failure is reached.
Any non-failing raw entropy value causes the health tests to reset.
The intermittent error has an unchanged significance level of 2^-30.
The permanent error has a significance level of 2^-60. Considering that
this level also indicates a false-positive rate (see SP800-90B section 4.2)
a false-positive must only be incurred with a low probability when
considering a fleet of Linux kernels as a whole. Hitting the permanent
error may cause a panic(), the following calculation applies: Assuming
that a fleet of 10^9 Linux kernels run concurrently with this patch in
FIPS mode and on each kernel 2 health tests are performed every minute
for one year, the chances of a false positive is about 1:1000
based on the binomial distribution.
In addition, any power-up health test errors triggered with
jent_entropy_init are treated as permanent errors.
A permanent failure causes the entire entropy source to permanently
return an error. This implies that a caller can only remedy the situation
by re-allocating a new instance of the Jitter RNG. In a subsequent
patch, a transparent re-allocation will be provided which also changes
the implied heuristic entropy assessment.
In addition, when the kernel is booted with fips=1, the Jitter RNG
is defined to be part of a FIPS module. The permanent error of the
Jitter RNG is translated as a FIPS module error. In this case, the entire
FIPS module must cease operation. This is implemented in the kernel by
invoking panic().
The patch also fixes an off-by-one in the RCT cutoff value which is now
set to 30 instead of 31. This is because the counting of the values
starts with 0.
Reviewed-by: Vladis Dronov <vdronov@redhat.com>
Signed-off-by: Stephan Mueller <smueller@chronox.de>
Reviewed-by: Marcelo Henrique Cerri <marcelo.cerri@canonical.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: Sasha Levin <sashal@kernel.org>
16 lines
574 B
C
16 lines
574 B
C
// SPDX-License-Identifier: GPL-2.0-or-later
|
|
|
|
extern void *jent_zalloc(unsigned int len);
|
|
extern void jent_zfree(void *ptr);
|
|
extern void jent_memcpy(void *dest, const void *src, unsigned int n);
|
|
extern void jent_get_nstime(__u64 *out);
|
|
|
|
struct rand_data;
|
|
extern int jent_entropy_init(void);
|
|
extern int jent_read_entropy(struct rand_data *ec, unsigned char *data,
|
|
unsigned int len);
|
|
|
|
extern struct rand_data *jent_entropy_collector_alloc(unsigned int osr,
|
|
unsigned int flags);
|
|
extern void jent_entropy_collector_free(struct rand_data *entropy_collector);
|