mirror of
https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git
synced 2025-01-14 09:25:12 +00:00
e317234975
Pull media updates from Mauro Carvalho Chehab: - V4L2 API additions to better support JPEG compression control - media API additions to properly support MPEG decoders - V4L2 API additions for image crop/scaling - a few other V4L2 API DocBook fixes/improvements - two new DVB frontend drivers: m88rs2000 and rtl2830 - two new DVB drivers: az6007 and rtl28xxu - a framework for ISA drivers, that removed lots of common code found at the ISA radio drivers - a new FM transmitter driver (radio-keene) - a GPIO-based IR receiver driver - a new sensor driver: mt9m032 - some new video drivers: adv7183, blackfin, mx2_emmaprp, sii9234_drv, vs6624 - several new board additions, driver fixes, improvements and cleanups. * 'v4l_for_linus' of git://git.kernel.org/pub/scm/linux/kernel/git/mchehab/linux-media: (295 commits) [media] update CARDLIST.em28xx [media] partially reverts changeset fa5527c [media] stb0899: fix the limits for signal strength values [media] em28xx: support for 2304:0242 PCTV QuatroStick (510e) [media] em28xx: support for 2013:0251 PCTV QuatroStick nano (520e) [media] -EINVAL -> -ENOTTY [media] gspca - sn9c20x: Cleanup source [media] gspca - sn9c20x: Simplify register write for capture start/stop [media] gspca - sn9c20x: Add automatic JPEG compression mechanism [media] gspca - sn9c20x: Greater delay in case of sensor no response [media] gspca - sn9c20x: Optimize the code of write sequences [media] gspca - sn9c20x: Add the JPEG compression quality control [media] gspca - sn9c20x: Add a delay after Omnivision sensor reset [media] gspca - sn9c20x: Propagate USB errors to higher level [media] gspca - sn9c20x: Use the new video control mechanism [media] gspca - sn9c20x: Fix loss of frame start [media] gspca - zc3xx: Lack of register 08 value for sensor cs2102k [media] gspca - ov534_9: Add brightness to OmniVision 5621 sensor [media] gspca - zc3xx: Add V4L2_CID_JPEG_COMPRESSION_QUALITY control support [media] pvrusb2: fix 7MHz & 8MHz DVB-T tuner support for HVR1900 rev D1F5 ...
tlg2300 release notes ==================== This is a v4l2/dvb device driver for the tlg2300 chip. current status ============== video - support mmap and read().(no overlay) audio - The driver will register a ALSA card for the audio input. vbi - Works for almost TV norms. dvb-t - works for DVB-T FM - Works for radio. --------------------------------------------------------------------------- TESTED APPLICATIONS: -VLC1.0.4 test the video and dvb. The GUI is friendly to use. -Mplayer test the video. -Mplayer test the FM. The mplayer should be compiled with --enable-radio and --enable-radio-capture. The command runs as this(The alsa audio registers to card 1): #mplayer radio://103.7/capture/ -radio adevice=hw=1,0:arate=48000 \ -rawaudio rate=48000:channels=2 --------------------------------------------------------------------------- KNOWN PROBLEMS: about preemphasis: You can set the preemphasis for radio by the following command: #v4l2-ctl -d /dev/radio0 --set-ctrl=pre_emphasis_settings=1 "pre_emphasis_settings=1" means that you select the 50us. If you want to select the 75us, please use "pre_emphasis_settings=2"